Single Ply Restoration

Restore and Preserve EPDM, TPO, PVC, and Other Membranes

single ply 1

EPDM (ETHYLENE PROPYLENE DIENE MONOMER)
1. Surface Prep

  • Carefully power wash to remove dirt, debris, and contaminants that could impede adhesion
  • Roof system must be clean and dry with surface temperature below 120°F at time of application
  • Correct ponding in low-lying areas prior to coating
  • All underlying materials must be fully cured

2. Repair & Seal

  • Repair tears and seams with like materials. Use a detail sealant like Elastek® #103 Crack & Joint, or ERSystems® HER Urethane Sealant, fabric reinforce where needed for seams and roof top penetrations

3. Prime

4. Finish Coat

  • Apply 2-3 coats of appropriate Elastek® finish coat
  • Apply with 3/4″ or 1-1/4″ nap roller or airless spray
  • Smooth Surfaces: Approximately 475 square feet per 5 gallon size pail per coat (approximately 100 square feet per gallon per coat). Apply two coats
  • Rough Surfaces: Approximately 100 square feet per 1.5 gallons per coat depending on porosity and roughness of surface. Apply two coats

TPO (THERMOPLASTIC OLEFIN)
1. Surface Prep

  • Carefully power wash to remove dirt, debris, and contaminants that could impede adhesion
  • Roof system must be clean and dry with surface temperature below 120°F at time of application
  • Correct ponding in low-lying areas prior to coating
  • All underlying materials must be fully cured

2. Repair & Seal

  • Repair tears and seams with like materials. Use a detail sealant like Elastek® #103 Crack & Joint, or ERSystems® HER Urethane Sealant, fabric reinforce where needed for seams and roof top penetrations

3. Prime

4. Finish Coat

  • Apply 2-3 coats of appropriate Elastek® finish coat
  • Apply with 1/2″ or 1-1/4″ nap roller or airless spray
  • Minimum two coats (20 Mils DFT total) for service life warranty
  • Smooth Surfaces: Approximately 475 square feet per 5 gallon size pail per coat (approximately 100 square feet per gallon per coat). Apply two coats
  • Rough Surfaces: Approximately 100 square feet per 1.5 gallons per coat depending on porosity and roughness of surface. Apply two coats

PVC (POLYVINYL CHLORIDE)
1. Surface Prep

  • Wash with TSP substitute and water; rinse
  • Power wash with clean water
  • Roof system must be clean and dry with surface temperature below 120°F at time of application
  • All underlying materials must be fully cured

2. Repair & Seal

  • Repair tears and seams with like materials. Use a detail sealant like Elastek® #103 Crack & Joint, or ERSystems® HER urethane sealant, fabric reinforce where needed for seams and roof top penetrations.

3. Prime

4. Finish Coat

  • Apply 2-3 coats of appropriate Elastek® finish coat
  • Apply with 3/4″ or 1-1/4″ nap roller or airless spray
  • Smooth Surfaces: Approximately 475 square feet per 5 gallon size pail per coat (approximately 100 square feet per gallon per coat). Apply two coats
  • Rough Surfaces: Approximately 100 square feet per 1.5 gallons per coat depending on porosity and roughness of surface. Apply two coats

Before & After Photos

single ply 2

single ply 3

Benefits

  • Reduce energy costs
  • Slow the aging process
  • Decrease future maintenance cost
  • Change the life cycle of the roof